Hello Mates ,
I’m so completely satisfied to indicate you my 2 ft tall Quilled Ganesha. It took round 6 months to finish this idol. I had made a 5 inch Ganesha idol . I had an concept to copy it – a a lot huge one. So I made a decision to attempt it.
The end result was implausible. I’m very completely satisfied. It will not have been doable with out the assistance and help of my household. I’ve used completely 3500 quilling strips to make the idol.
I’ve primarily used 10 mm Quilling strips for my Mission. I’ve captured just a few footage whereas making it . Let me share …
1. Face and Trunk :
- For the face make a open coil adopted by a cone utilizing 150 quilling strips. I’ve used 10 mm cream color strips.
- Make one other cone utilizing 50 quilling strips. 10 mm cream color strips.
- Make 2 open coils utilizing 125 quilling strips. This coil will likely be hooked up to the face.
- For the trunk make a cone utilizing 150 strips. Use 10 mm gold color strips.
- Connect the face and the crown .
2. Ears :
- Make a decent coil utilizing 100 quilling strips. I’ve used 10 mm yellow color strips. Make the coil into an ear form.
3. Crown :
- Make a cone utilizing 150 strips of gold color .
- For the again a part of the crown , I’ve made an open coil utilizing the approx 250 strips.
- It is advisable to hold rolling the coil to get the specified measurement. Discuss with the pic.
- Adorn the crown with kundans.
4. Higher Physique:
- Make a decent coil utilizing 600 strips. I’ve used cream color strips. Make a dome form.
- Make two such coils and connect them as proven beneath.
- Make one other cone utilizing 300 gold color strips. Connect them as proven.
5. Decrease Physique:
- Make a decent coil utilizing 200 strips ( blue color ). Use 10 mm strips. Make a bucket form and stick it to the higher physique half as proven.
- Stick the face half with the higher and decrease physique elements.
- For the legs it’s good to make a cone utilizing 150 quilling strips ( 10 mm ).
6. Palms:
- Make a decent coil adopted by a cone form utilizing 125 quilling strips. The diameter of the coil is approx 3.5 inch.
- Make an identical dimension coil for the shoulder. Bend it right into a cup form.
- Make one other coil of dimension 2.5 inch . Give it a cone form and connect it to the large coil.
- The opposite two fingers are made utilizing 70 quilling strips.
7. Palm and ft :
- You possibly can consult with my earlier posts to make the palm and ft.
- I’ve used 40 strips for the palm .
- And round 30 strips for the ft.
8. Pasha and Ankusha :
9. Mouse ( Mooshika ) :
- For this you want 10 mm gray color quilling strips. Make three tight coils .
- The primary coil is product of 15 strips.
- The second and third coils are product of 25 strips.
- Mould the tight coil within the applicable form as proven .
Connect all of the elements of the idol and your lovely and sumptuous Lord Ganesha is prepared . You possibly can enhance with some jewelry and equipment.
I wish to convey my particular due to my daughters for all the trouble and help . Thanks pricey 💖.
All the gorgeous and vibrant Quilling strips which I’ve used for my Magnificent Ganesha are from Moksha Quilling Hub. Thanks Moksha 💖. . The standard and vibrant colors of the quilling strips are lovely . I’d suggest everybody to attempt .
